Views: 0 Author: Site Editor Publish Time: 2023-12-11 Origin: Site
EPS components are made of EPS as the core aggregate, with external grid cloth and polymer mortar materials, and are used as decorative components for building facades. This type of EPS component has been rapidly promoted and applied in recent years, with good results. EPS components have an average appearance, extremely light weight, fluent lines, and minimal errors, allowing for easy cutting and splicing. The installation is easy and convenient, which not only prevents many difficulties and cumbersome processes in installation, internal and external corner splicing, and high-altitude transportation of traditional exterior wall building decorative components such as EPS sculptures, but also greatly reduces the risk of high-altitude operations. It also addresses the inevitable cold and The phenomenon of thermal bridges and many other difficulties have saved a lot of installation time and cost for the project, and improved the safety of equipment operation. EPS European foam line relies on the steel frame and embedded reinforcement on the main structure to stop effective connection and fixation. If the line cracks due to the decoration of embedded reinforcement, it will cause line fracture.
Before the construction of EPS decorative lines, it is necessary to clean the remaining floating ash, release agent oil stains and other debris on the concrete wall, as well as the hollow areas of the plaster. Remove concrete blocks, inclusions, hollows, etc. that have cracked at the joints of the wall, and stop repairing them again; The window sill eaves are sloped with 2% cement mortar, and various openings on the exterior wall are filled tightly. Request the surface flatness deviation of the polystyrene board to not exceed 5mm. If it exceeds the tolerance, stop polishing the protruding wall surface and repair the concave parts (if the repair thickness exceeds 6mm, use 1:3 cement mortar for plastering, and if the repair thickness is less than 6mm, use polymer bonded mortar by the insulation construction unit for repair); To ensure the flatness of the entire wall surface is within 5 mm, with square and unobstructed internal and external corners.